Sweep Control Valve
These are what control the distance of rebound and damping force and/or sweep, from the centerline out to each side. In order to determine where the left and right sweep control are set, you will notice a dot and/or circular marker on one side of the slot head groove that is the INDEX. If setting is at 3 o’clock, the right-side valve would face toward the FRONT of the bike and the left-side valve would be facing towards the BACK of the bike.
At the 12 o’clock setting both would be facing UP, one to the left and the other one to the right.
At the 6 o’clock setting both would be facing DOWN again one to the left and the other to the right.
Sweep Control is located on each side & are normally set at the twelve o’clock position.
Base settings are as follows:
Location: The sweep-control valve are locate don both sides of you stabilizer.
Starting position: At the 12 o’clock setting both would be facing UP.
Fine Tuning the Sweep-control. Is adjusted through the front valve located at the front of your stabilizer, base settings are 2˝ turns out from fully closed.
ALL ICS STABILIZER ARE PRESET IN THE NATURAL POSITION.
View Printable PDF Version
« Back
|
